RESCUEJCK
03-08-1999, 12:15 AM
Has anyone ever heard of using a seatbelt, tide in a loop and wrapped around the Bake, or clutch pedal to displace them.
If not , heres how to do it.
1. Take a seatbelt, out of the car that you are working on, and pull it all the way out, then cut it.
2. Take the seatbelt and tie it in a loop using a "water knot".
3. Run it around the pedal that you need to displace, and run it through itself.
4. Place a spreader, with the tips facing towards the back of the car against the front fender, or kick panel area.
5. Place the end of the loop that you have left, over the tip of the spreader, and open the jaws (Oh ya, you have to remove the door before you do any of this)
I tried this at a recent class that I was teaching, and it worked rather well. It not only pulls the pedal to the side, but up as well. I also recommend that you use a new belt everytime, and don't use a belt that was being used by an occupant of the vehical. (Remember the rules for rope that has been used in a rescue)
If not , heres how to do it.
1. Take a seatbelt, out of the car that you are working on, and pull it all the way out, then cut it.
2. Take the seatbelt and tie it in a loop using a "water knot".
3. Run it around the pedal that you need to displace, and run it through itself.
4. Place a spreader, with the tips facing towards the back of the car against the front fender, or kick panel area.
5. Place the end of the loop that you have left, over the tip of the spreader, and open the jaws (Oh ya, you have to remove the door before you do any of this)
I tried this at a recent class that I was teaching, and it worked rather well. It not only pulls the pedal to the side, but up as well. I also recommend that you use a new belt everytime, and don't use a belt that was being used by an occupant of the vehical. (Remember the rules for rope that has been used in a rescue)