Why register? ...To Enhance Your Experience
+ Reply to Thread
Results 1 to 2 of 2
  1. #1
    MembersZone Subscriber
    Join Date
    Jan 2004
    Location
    New Mexico
    Posts
    140

    Default Pneumatic Hurst Tools

    I have a question for all of you Hurst fans out there. Our department uses the air - powered Hurst combo tool. If anyone has any experience with these, I would really appreciate some input. We were trying to cut hinge pin off of door, took 15 minutes, and 6 30-min. bottles. One prob. , which has already been addressed, regulator was st at 90 psi. Local dealer says @ 125 psi, tool should perform same as hydraulic model. Is this accurate ? Also, would a larger supply of air, such as a cascade system, improve their performance ?


  2. #2
    Junior Member
    Join Date
    Oct 2003
    Location
    central ohio
    Posts
    23

    Default

    Why would you cut a hinge pin...Its hardened steel..???

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts