Looking for information in regards to jet siphon operation. We received little info from the manufacturer and it's winter here in Canada so I would like to do as much research from my computer as possible rather than outside. Can you tell me what pressure to run the intake to the siphon at to start the transfer? What kind of transfer rate will you get approx? If you stop the flow into the siphon does the flow continue or does it require constant intake pressure? Anyone have a guideline/SOP/training precis they want to share? The siphon is a low level type with one and a half inch inlet and 4 inch discharge. Any help would be appreciated.
+ Reply to Thread
Results 1 to 3 of 3
Thread: Jet Siphon Operation
02-22-2006, 08:47 AM #1
Jet Siphon Operation
02-22-2006, 07:13 PM #2
Dr......go to the apparatus forum .........it has been discussed there before if you do some diggin around.IACOJ both divisions and PROUD OF IT !
Pardon me sir.. .....but I believe we are all over here !
ATTENTION ALL SHOPPERS: Will the dead horse please report to the forums.(thanks Motown)
RAY WAS HERE 08/28/05
LETHA' FOREVA' ! 010607
I'm sorry, I haven't been paying much attention for the last 3 hours.....what were we discussing?
"but I guarentee you I will FF your arse off" from>
02-22-2006, 07:19 PM #3Dr......go to the apparatus forum .........it has been discussed there before if you do some diggin around.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By PaulBrown in forum World of Fire Daily ReportReplies: 0Last Post: 02-15-2006, 10:51 PM
By 5pts384 in forum Firefighters ForumReplies: 20Last Post: 01-16-2006, 04:06 AM
By PaulBrown in forum World of Fire Daily ReportReplies: 0Last Post: 10-16-2005, 10:44 AM
By HF&R_H28 in forum Firefighters ForumReplies: 8Last Post: 05-09-2002, 04:45 PM
By Lewiston2Capt in forum Firefighters ForumReplies: 3Last Post: 04-01-2001, 12:13 PM