In the event a firefighter suddenly and unexpectedly falls into deep water while wearing full turnout gear, the firefighter's survival is dependent upon the immediate actions taken during the first critical seconds of immersion. The potential for this type of emergency always exists when firefighters are fighting apartment or other structure fires around a swimming pool; during suppression activities on and around piers and docks; as well as in the event of a fall-through incident in which the firefighter falls through a floor into a basement filled with water.
As soon as the firefighter hits the water, his/her turnout gear will immediately trap air which rapidly floats the firefighter to the surface of the water. As soon as the firefighter reaches the surface, he should immediately assume a horizontal position on his back (supine position), by kicking his feet out in front of him.
This procedure is contrary to the firefighter's natural instinct which would cause him to attempt to go vertical in the water. However, if the firefighter assumes a vertical position while in the water, the trapped air in the firefighter's turnout gear will escape through the neck of the turnout coat causing him to lose buoyancy and putting him at risk of sinking under the water's surface.
Therefore, firefighters need the opportunity to practice this procedure under controlled conditions until they are comfortable in doing so, and the appropriate behavior of assuming a supine position in the water becomes an automatic response.
The firefighter will float in a prone (on his front) position as well. Whether the firefighter assumes a prone or supine horizontal position should be dependent upon the comfort level of the firefighter. However, it is this author's position that if the firefighter is wearing SCBA, as he would during structural firefighting/suppression activities, it is safer and more comfortable for the firefighter to assume a supine horizontal position. It is our hope that this article and the supporting photographs will clarify this position.
Wearing full turnout gear with SCBA increases the weight of a firefighter by approximately 60 lbs. When the turnout gear is wet, approximately 40 lbs. of additional weight is added as a result of the absorbed water into the pockets and lining of the turnout gear. Yet, even with the additional 100 lbs. of weight, after the firefighter falls into the water, he will immediately float to the surface as a result of the trapped air inside his turnout gear. The firefighter can safely maintain his buoyancy in the water while working his way to safety or until he can be rescued by other firefighters.
Once immersed, the SCBA will automatically free-flow air. Due to the positive pressure in the air mask, as long as the seal has not been compromised, the firefighter can continue to breathe with the mask in place.
Immediately after falling into the water, the firefighter needs to assume a horizontal position in the water. If he attempts to get vertical, all the trapped air will escape from the neck and arms of the turnout coat and the firefighter will immediately lose his buoyancy. While maintaining a horizontal position in the water, the firefighter should use only underwater arm movements to progress himself to safety. Overarm movements will again result in losing air from the turnout coat, and the weight of the arms will lead to exhaustion of the firefighter.
The firefighter's turnout gear can assist him in staying afloat. The firefighter's helmet can be used to trap air and when placed over the hips, will help to elevate the firefighter's hips in the water.
If the firefighter is wearing rubber pull-on boots, he can remove one, or both boots, empty the water from them, and then invert them to trap air. The trapped air inside the boot provides sufficient buoyancy to keep the firefighter afloat.
It is the opinion of this author that the best horizontal position for the firefighter to assume when wearing SCBA is the supine position (on the back). This position allows the firefighter to assume a good horizontal position with the toes of his feet near the surface in order to trap air in his boots. It also provides the best advantage for seeing his surroundings, as well as for using the underwater arm movements. Should the firefighter need to dump his SCBA, the supine position allows the firefighter the best access to the SCBA straps. Should additional air need to be added within the turnout coat, this can easily be accomplished with the firefighter in this position by splashing water into the bottom of the turnout coat.
Some authorities recommend a prone (on the front) position. However, by assuming this position, the SCBA bottle prevents the firefighter from removing his head from the water, especially if he is still wearing his helmet.
Furthermore, by overcompensating and lifting his head higher out of the water, this tends to place the immersed firefighter in a more vertical position which results in his losing trapped air from the turnout coat.
We encourage all Fire and Rescue Departments to provide the opportunity for firefighter personnel to practice these survival procedures while wearing full turnout gear. These practical evolutions should be performed in shallow water under the watchful eye of an Instructor. After these skills are mastered and the firefighter is comfortable in the water with his gear, these skills should then be practiced in deep water. We recommend these skills be practiced by one firefighter at a time in the water along with an in-water Instructor. The in-water Instructor should have a buoyant device (i.e. Rescue Tube) available should the firefighter panic and/or lose his buoyancy.
As a practical evolution in Lifesaving Resources' Water Rescue Technician Courses, the student, while wearing turnout coat, bunker pants, and helmet, jumps into the water near the Instructor. While doing so, the student places one hand across and just above his eyebrow line so that the brim of the helmet does not slam into the bridge of his nose when the water hits the helmet's beaver tail. The Instructor directs the student to remove the helmet, empty it of water, and then slowly place it across his hips to feel the buoyancy. The Instructor then hands the student a boot and instructs him to empty the boot of water by inverting it and holding it over his head, and then slowly move it vertically into the water to trap air. After the student accomplishes this, the instructor directs the student to refill the turnout coat with air by picking up the waist and aggressively splash water and air into the coat while swimming on his back to safety.
For more information on Lifesaving Resources and their Water Rescue and Ice Rescue Technician training curriculums, access the Educational Programs Section of the Lifesaving Resources' web site at http://www.lifesaving.com, or call 603-827-4139.